STARR GUITAR replacement electronics for Gibson Thunderbird 3 control Bass! Each set is assembled, hand wired and soldered in the USA by Dave Starr using premium parts. Upgrade your import bass electronics, or replace your old worn out parts with these premium replacement units! Simply attach your pickup wires, and bridge ground wire and you are ready to rock! All sets are signed by Dave Starr and have their own serial number. FREE SHIPPING IN THE USA! Included in each SGS “Standard” Thunderbird Bass Harness: 2) CTS 500K Audio Pots (Volume Controls), split shaft, with Nut, Lock, and Dress Washer 1) CTS 250K Audio Pot (Master Tone), split shaft, with Nut, Lock, and Dress Washer 1) “Orange Drop” .047 mfd 100 volt Capacitor 4) Gavitt vintage style push back black (ground) and white (hot) cloth covered wires, 22 gauge, with a waxed braided cotton outer insulation. 1) 18 gauge solid tinned copper master ground wire 1) Switchcraft #11L input jack with heat shrink strain relief on both terminals 1) Wiring diagram (see photo section)1) Assembly template board IMPORTANT: if your bass needs the long switchcraft #151 cannon style jack, I have them here at this link:www.ebay.com/itm/Switchcraft-151-Mono-Long-Threaded-Jack-with-GAVITT-Wire-NEW/283455306152 Note: Most guitars manufactured overseas in South Korea, Japan, China, Indonesia and Mexico use 6mm metric pots and have metric sized holes drilled. If so, you will need to enlarge the pot holes to 3/8″ to fit these CTS pots properly. Starr Guitar Systems PO Box 3132 Conroe, Texas 77305 www.facebook(dot)com/starrguitarsystems WHO WE ARE:Starr Guitar Systems (SGS) owner Dave Starr has been playing guitar and bass professionally (WildeStarr, Vicious Rumors, and CHASTAIN) for over 30 years, and doing guitar repair for over 30 years as well. Dave has put his years of experience as a pro to come up with his own line of guitar & bass electronic upgrade systems. So, when you buy from Dave, you are not just buying gear from a guitar technician… you are buying gear from a PRO MUSICIAN who has been there and done that….. recorded over 15 albums, toured the world multiple times, MTV videos, artist endorsements (currently signed with ERNIE BALL strings and EMG pickups), etc. Every SGS unit comes with all of that experience behind it… what works and what doesn’t, because Dave has pretty much seen and done it all. And, every SGS unit is custom built and assembled by hand one at a time by Dave here in his Houston Texas shop.www.wildestarr.comwww.facebook.com/DaveStarr7777www.facebook.com/starrguitarsystemswww.ernieball.com/artists/dave-starrwww.emgpickups.com/artist/index/view/id/407
